Quickstart
- Heather Hartman (Unlicensed)
- Mushtaq Ahmad (Unlicensed)
This setup process quickly configures the ArcMail appliance to begin archiving. Refer to the values you entered in the Network Worksheet located in the Prep and Install Guide.
Figure 1-52- QuickStart Step 1
Enter the appropriate values in the following fields using the Network Configuration Worksheet completed during the Pre-Installation section:
Procedure 1-33 - Perform the following steps to complete the QuickStart Configuration:
Step Action
1 The following four fields are populated from the network setup in the Pre-Configuration section.
• IP address - The IP address is not editable in this wizard. To edit the IP address, click Network Interface.
• Network address - The Network address is not editable in this wizard. To edit the Network address, click on General Options under the CONFIGURATION icon.
• Hostname - Enter the fully qualified hostname for the appliance.
• Primary Domain - Enter the appliance domain name.
2 Click Next.
Figure 1-53- QuickStart Step 2
3 Populate the following fields:
• Archiver email address - The email address that your mail server uses to send archived mail to the appliance. This email address must match the archiving contact set up later in the Configure the Email Server section. The domain to the right of the ‘@’ symbol must be the fully qualified hostname provided to the appliance.
• Admin email address - This email address receives the appliance’s daily reports and any error messages.
4 Click Next.
Figure 1-54- QuickStart Step 3
5 Populate the following fields:
• Mail domain - The appliance archives for this email domain.
• Maps to address - This is the IP address of the email server in the Mail Domain
field.
6 Click Next.
Figure 1-55- Quickstart Step 4
7 Click Save. The Apply Changes screen appears.
Figure 1-56- Apply Changes Screen
8 Click Apply. This applies the new settings and restarts the appliance software. This operation is complete when “Configuration settings applied” is shown at the bottom of the screen.
Note: This is the best time to check for system updates for the ArcMail appliance. Click SUPPORT, then click System Updates.